SAFETY INSTRUCTIONS
CAIMAN® CORE DRILL BITS
U.S.A. - ANSI B7.1 and OSHA regulations; Canada – CSA
1. Observe the working safety site regulations.
2. Keep bystanders and/or animals out of the work area.
3. The use of OSHA approved safety goggles, gloves, footwear, ear and head protection and a mask are recommended.
4. Before use, examine the Caiman® diamond core bit for any cracks or other damage. Do not use if damage is suspected.
5. Ensure that the Caiman® diamond core bit is suitable for the material being cut.
6. Disconnect power to the machine before mounting the Caiman® diamond core bit.
7. Ensure that the Caiman® diamond core bit is securely fastened to the machine. If the Caiman® diamond core bit does not securely fit, a washer may be put between the Caiman® diamond core bit and the machine to ensure a tight fit.
8. Ensure that the coring surface is clean from debris.
9. Use of the Caiman® diamond core bit is recommended on a stationary core machine. If using the Caiman® diamond core bit on a hand-held machine, maintain a straight cutting plane to avoid side load or twist. The use of a guide or pilot may help the Caiman® diamond core bit maintain a straight core through the material being cut.
10. Maintain a firm grip on the tool during coring.
11. Ensure that adequate water is properly disbursed to the Caiman® diamond core bit so that there is sufficient cooling. A water containment device is recommended for coring indoors.
12. Ensure that the proper RPM is used to avoid overheating and glazing.
13. Before coring, let the tool run for a few seconds without load. If the Caiman® diamond core bit wobbles, vibrates or has an unusual noise, stop the tool immediately. Examine the Caiman® diamond core bit for damage or incorrect mounting.
14. To ensure longer diamond life, avoid sharp or abrupt contact with the material being cut.
15. If using a hand-held machine, do not rock the Caiman® diamond core bit side to side when coring. Rocking may cause the segments (or continuous diamond wall) of the Caiman® diamond core to detach from the shank and possibly cause injury. Simply use adequate pressure on the Caiman® diamond core bit while maintaining a straight cutting plane.
16. Do not use the Caiman® diamond core bit for extensive periods. Excessive heat can cause vibration and glazing. To assist cooling, simply lift the Caiman® diamond core bit out of the cut for several seconds and then continue coring.
17. Reduce pressure as the Caiman® diamond core bit reaches the point of break through on the material being cut.